Tag Archives | McMillan Tips

Webinar-How-to-Get-the-Most-Out-of-Control-Valves

Webinar Recording: How to Get the Most out of Control Valves

The data that is really needed when selecting and sizing a control valve is rarely understood and specified, which leads to excessive variability originating from the valve. In this presentation, ISA mentor Greg McMillan discusses pervasive problems and rampant misconceptions. He then provides guidance—supported by test results—on how to select a good throttling control valve. […]

Continue Reading · 0
Optimize-Process-Operations-with-Wireless-Measurements

How to Overcome Challenges of PID Control and Analyzer Applications via Wireless Measurements

Wireless measurements offer significant life-cycle cost savings by eliminating the installation, troubleshooting, and modification of wiring systems for new and relocated measurements. Some of the less recognized benefits are the eradication of EMI spikes from pump and agitator variable speed drives, the optimization of sensor location, and the demonstration of process control improvements. However, loss […]

Continue Reading · 0
PID-Tuning-Rules

PID Tuning Rules

Nearly every automation system supplier, consultant, control theory professor, and user has a favorite set of PID tuning rules. Many of these experts are convinced their set is the best. A handbook devoted to tuning has over 500 pages of rules. The enthusiasm and sheer number of rules is a testament to the importance of […]

Continue Reading · 0
vessel-control-loops-need-reset-time-increased-by-two-or-more-orders-of-magnitude-slider

How to Avoid Common Tuning Mistakes

The proportional, integral, derivative (PID) controller is the common key component of all control loops. Basic control systems depend upon the PID to translate the measurement signals into set points of secondary loop controllers, digital valve controllers, and speed controllers for variable frequency drives. The success of advanced control, such as model predictive control, depends […]

Continue Reading · 1
industrial-applications-thermal-mass-flowmeters

The Good, Bad and Ugly of Thermal Mass Flowmeters

Thermal mass flowmeters can be a relatively inexpensive flowmeter that can handle extremely small flows (e.g., inline 1/16-inch meters) and large flows (e.g., multipoint insertion type in 60 inch ducts). Thermal flowmeters introduce heat into the flow stream and measure how much heat is absorbed using one or more temperature sensors. However, the meter requires […]

Continue Reading · 2
near-integrating-process-response

PID Tuning for Near and True Integrating Processes

The most important loops on vessels and columns typically have a near or true integrating response. A self-regulating process is classified as near integrating if the process time constant is larger than four times the process dead time. The composition, pH, and temperature response of continuous columns tend to have a time constant to dead […]

Continue Reading · 0